The ice maker operates on water pressure of 20 psi (1.4 bar) to 100 psi (6.9 bar). To obtain local dealer information, visit the Locator section of our website, .Ī line filter is required when water conditions have a high sediment content. A saddle valve kit (4200880) is available from your Sub-Zero dealer. Connect a 1/ 4" OD copper line to the house supply, being sure to use an easily accessible shut off valve between the supply and the unit.ĭo not use self-piercing valves. Refer to pages 6–10 for detailed information on adding panels.įor Built-In models with an automatic ice maker, rough in the water supply line. The overlay design also allows you to add your own handles, or you may choose accessory handles available through your Sub-Zero dealer. If your client has chosen the framed or overlay design, you will be adding front panels to give the unit the custom Sub-Zero look. You will not have to install front panels. If your client has chosen the stainless steel design, the unit will be shipped complete with wrapped stainless steel doors and handle hardware. Refer to the full-scale illustrations at the end of this section for specifics on door openings and filler size alternatives. In any side- by-side installation without a filler strip, add an additional 1/ 2" (13) to your combined numbers. This kit is available through your Sub-Zero dealer.īe sure to add the filler strip width to your finished rough opening dimension. An anchoring kit may also be used to attach two units together. The width of this filler strip will vary depending on the configuration and panels you use. When units are installed side by side, a filler strip is recommended. A 90˚ door stop is available as an accessory. If you're using raised panels, consider using a wider filler. Refer to the minimum door swing clearance in the specifications chart.įor corner installations, allow for a minimum 3" (76) filler so that the door can open to 90˚. With the door opening at 90˚, you may have to move drawers slightly to clear the door interior. Refer to the illustrations and specifications for overall dimensions, finished rough opening dimensions and installation specifics.Īllow the door to open a minimum of 90˚ or you'll have problems removing drawers.
0 Comments
Leave a Reply. |